副井信号操车设备远程控制设计与应用

副井信号操车设备远程控制系统是数字化矿山建设的重要组成部分，此系统应用计算机网络技术、可编程控制器技术、无线通信技术、传感器检测技术和视频监控技术，以总线冗余、Profibus-DP现场总线控制和工业以太网为基础组成的数字化网络控制系统。通过将原系统分段独立的控制方式改造成集中遥控和远程操作的方式来减少副井提升机各中段水平的岗位操作人员数量、提高设备的安全性和生产效率，适用于地下矿山企业的长期生产工况作业，是智慧化矿山建设的必然趋势。     

Measurement of solubility and diffusion coefficients of ethylene in solid and molten low-density polyethylene with different melt indices

The diffusion behavior of ethylene in polyethylene is of great importance for the polymerization and degassing of polyethylene (PE) industry. Based on the gravimetric sorption and desorption measurement approach, an intelligent gravimetric analyzer is applied to obtain the solubility and diffusion coefficients of ethylene in solid low-density PE (LDPE) with different melt indices at 30°C to 70°C, 0 to 4 atm and in molten LDPE at 160°C to 230°C, 0 to 4 atm, respectively. Results indicate that both the solubility and diffusion coefficients of ethylene in solid LDPE are smaller than those in molten LDPE, while the dissolution enthalpy and diffusion activation energy of ethylene in solid LDPE are higher. In addition, one- and two-dimensional diffusion models are built and the effects of particle size, polymer properties, and operation conditions are systematically investigated on the diffusion behaviors of ethylene in solid and molten LDPE.     

石粉含量与钢纤维长度对机制砂超高性能混凝土性能的影响

为利用机制砂作细集料制备一种低成本的超高性能混凝土(UHPC),研究了石粉含量(5％ 、7％ 、10％ 、12％ 、15％)与3种长度的钢纤维及其2种钢纤维混杂对花岗岩机制砂UHPC的工作性能和力学性能的影响规律,并与河砂UHPC进行了对比.结果表明,机制砂UHPC的流动性低于河砂UHPC,且随石粉含量的增加而显著降低,机制砂UHPC的抗压强度、抗弯拉强度和弹性模量随石粉含量的增加呈先增大后降低趋势,当石粉含量≥10％ 时,机制砂UHPC的各项力学性能高于河砂UHPC.在钢纤维总体积掺量保持2％ 不变情况下,随钢纤维长度增加,UHPC的流动性降低,力学性能增大;当1％ 的长度13 mm平直钢纤维和1％ 的长度20 mm端勾钢纤维混杂时,机制砂UHPC的各项力学性能最佳.     

Theoretical investigation of solvent effects on the selective hydrogenation of furfural over Pt(111)

It was well known that solvent effect plays a very important role in the catalytic reaction. There are many theoretical studies on the solvent effect in homogeneous catalysis while there are few theoretical studies on the solvent effect in the heterogeneous catalytic reaction and there has been no work to investigate the solvent effect on furfural transformation in heterogeneous catalysis. In the present work, both the density functional calculations and the microkinetic analysis were performed to study the selective hydrogenation of furfural over Pt(111) in the presence of methanol as well as toluene and compared with that in the gas condition. The present results indicated that the methanol can enhance the adsorption strength of furfural and other oxygen-containing reaction species due to its relatively strong polarity properties and this can be a main reason for solvent-induced high activity and selectivity. Another reason is that reaction paths study showed that the presence of methanol solvent makes the dehydrogenation of furfural less thermochemical due to the fact that furfural is more stabilized than that of dehydrogenation species, and methanol also has an inhibition effect on the dehydrogenation of furfural in the kinetic aspect, and further energetic span theory proves highest activity and selectivity for hydrogenation in methanol solvent of vapor, methanol and toluene. Moreover, microkinetic model simulation demonstrated that the activity and selectivity of hydrogenation in methanol is both higher than that in vapor and toluene. The much higher activity in methanol is due to the stabilized adsorbed reactants in the surface, which leads to a higher surface coverage of furfural. It might be proposed based on the present work that a solvent with relatively strong polarity may be favorable for the high selective hydrogenation of furfural.     

井工转露天采区顶板厚度不足诱发滑坡问题研究

井工转露天开采是安全生产遇到的新问题。以紫金山金铜矿为背景，利用数值模拟法系 统研究了井 工转露天开采工况下顶板厚度从 68 m 逐渐减小至 44 m 时顶板的安全性，界定出顶板最小安 全厚度为 45 m。同时 系统研究了顶板厚度变化对上部边坡应力场的影响特点，得出随着顶板变薄坡脚处塑性破坏区 增大，导致边坡稳 定性变小的规律，并通过边坡稳定性分析计算验证其正确性。因此在井工转露天开采过程中， 为了确保安全生产 需要确保顶板有足够的厚度，避免作业设备和工作人员坠入老井采区及滑坡灾害发生。     

Classification of DoS Attacks in Smart Underwater Wireless Sensor Network

As per the most recent literature, Orthogonal Frequency Division Multiplexing (OFDM), a multi access technique, is considered most suitable for the 3G, 4G and 5G techniques in high speed wireless communication. What made OFDM most popular is its ability to deliver high bandwidth efficiency and superior data rate. Besides it, high value of peak to average power ratio (PAPR) and Inter Carrier Interference (ICI) are the challenges to tackle down via appropriate mitigation scheme. As a research contribution in the present work, an improved self-cancellation (SC) technique is designed and simulated through Simulink to mitigate the effect of ICI. This novel proposed technique (Improved SC) is designed over discrete wavelet transform (DWT) based OFDM and compared with conventional SC scheme over different channel conditions i.e. AWGN and Rayleigh fading environments. It is found that proposed DWT-OFDM with Improved SC scheme outperforms conventional SC technique significantly, under both AWGN and Rayleigh channel conditions. Further, in order to justify the novelty in the research contribution, a Split-DWT based Simulink model for Improved SC scheme is investigated to analyse the BER performance. This Split-DWT based Simulink model presented here foretells the future research potential in wavelet hybridization of OFDM to side-line ICI effects more efficiently.

     

Effects of B2O3 on Crystallization,Structure, and Heat Transfer of CaO-Al2O3-Based Mold Fluxes

Metallurgical and Materials Transactions B - The reaction between traditional CaO-SiO2-based mold fluxes and high-Al steel inevitably changes flux composition, and, consequently, flux properties....     

转底炉处理赤泥工艺技术

为了综合利用氧化铝冶炼产生的赤泥，探索在转底炉中直接还原赤泥、磨矿磁选获得高品位直接还原铁。通过实验室试验摸索了转底炉还原工艺参数，并在转底炉工业试验线进行了工业试验。实验室结果表明，赤泥还原后的直接还原铁(DRI)金属化率可达88.6%，磁选后的铁品位可达82.1%，磁选后的铁回收率可达88.9%。工业试验中，转底炉还原后，产品金属化率平均为69.2%，将还原后的DRI磁选获得高品位的DRI产品，磁选后DRI的铁品位为72.8%，磁选后铁回收率达到了85.2%,初步打通了在转底炉中还原赤泥、磁选的工艺路径。     

面向草莓抓取的气动四叶片软体抓手研制

农林业中果蔬的自动化采摘需求日趋强烈,末端抓手是实现无损采摘的关键。传统的末端抓手以刚性结构居多,现有的各种柔性抓手也存在抓取力不足、包覆性不佳等缺点。本文以草莓的无损采摘为研究对象,提出将草莓外部轮廓曲线作为设计曲线,设计了一种新型气动四叶片软体抓手。首先,对软体抓手的结构做仿真优化,提出一种安全地附着在目标物表面的设想。然后,在进行草莓表面的最小破坏应力试验的基础上,测试了软体抓手的末端力,验证了其实现无损抓取的可行性。再次,利用动态捕捉技术,研究了软体抓手叶面的弯曲变形规律。最后,选择使用弧线型气体通道的软体抓手进行了草莓抓取测试,结果证明了气动四叶片软体抓手可以实现草莓的无损抓取,抓取成功率达90%,破损率为2%,表明所研制的四叶片软体抓手用于草莓抓取时具有良好的稳定性和实用性,可用于草莓采摘的末端执行器。本研究也可为其他易损果蔬的采摘技术提供理论基础和技术支撑。     

Evaluation of bismuth doped La2-xBixNiO4+δ (x = 0, 0.02 and 0.04) as cathode materials for solid oxide fuel cells

Bismuth doped La_2-xBi_xNiO_4+δ (x = 0, 0.02 and 0.04) oxides are investigated as SOFC cathodes. The effects of Bi doping on the phase structure, thermal expansion, electrical conduction behavior as well as electrochemical performance are studied. All the samples exist as a tetragonal Ruddlesden-Popper structure. Bi-doped LBNO-0.02 and LBNO-0.04 have good chemical and thermal compatibility with LSGM electrolyte. The average TEC over 20–900°С was 13.4 × 10^?6 and 14.2 × 10^?6 K^?1 for LBNO-0.02 and LBNO-0.04, respectively. The electrical conductivity was decreasing with the rise of Bi doping content. EIS measurement indicates Bi doping can decrease the ASR values. At 750 °C, the obtained ASR for LBNO-0.04 is 0.18 Ωcm², which is 56% lower than that of the sample without Bi doping, suggesting Bi doping is beneficial to the electrochemical catalytic activity of LBNO cathodes.